Constant regulation system 1-10V

Main features of the 1-10V constant regulation system:
- Automatic energy saving system for 1-10V luminaires: automatically applies the required brightness level to the lamps to maintain a previously established minimum lighting level (for example 500Lux ), compensating for natural light at all times.
- It incorporates a motion sensor (PIR), which allows lighting activation to be limited to the presence of people if desired.
- Two operating modes: Automatic (Automatic Regulation + Motion Detection) or Automatic Regulation (without motion detection).
- Factory pre-adjusted to achieve a level of 500Lux, approximately at the workplace, assuming installation in a “standard” office.
- Possibility of adjusting the minimum dimming level, preventing the lights from turning off completely.
- Surface mounting on the ceiling.

Technical characteristics of the const dimming system before 1-10V:
- Supply voltage: 230VAC
- Frequency: 50/60Hz
- Output channels: 1
- Relay breaking capacity: 16A
- Type of terminals Elevator connection
- Cable section: 2.5mm2
- Storage temperature (min): -30ºC
- Storage temperature (max): 70ºC
- Minimum time delay: 10 minutes
- Maximum timing: 30 minutes
- Detection angle: 360º
- Mounting height: 2.5m
- Detection diameter: 7m
- Own consumption: 2W
- Load type: Ballast o Driver 1/10Vdc
- Light level (min): 100lux
- Light level (max): 1000lux
- Maximum absorption current per 1/10V: 500mA
- Maximum injection current per 1 /10V: 250mA
- Maximum number of devices: 80
- Installation: Ceiling surface
- Operating temperature (min): 0ºC
- Operating temperature (max): 40ºC
- Environmental Protection: IP20 according to UNE 20324
- According to the Standard: UNE-EN 60730