Dali constant regulation system

Main features of the Dali constant dimming system:
- Automatic energy saving system for DALI luminaires: automatically applies to the lamps the level of luminosity required to maintain a previously established minimum lighting level (for example 500Lux), compensating for the natural light at all times.
- It incorporates a motion sensor (PIR), which allows limiting the lighting activation to the presence of people if desired.
- Two operating modes: Automatic (Automatic regulation + Motion Detection) or Automatic Regulation (without motion detection).
- Factory pre-adjusted to achieve a level of 500Lux, approximately at the workplace, assuming installation in a "standard" office.
- Possibility of adjusting the minimum dimming level, preventing the lights from turning off completely.
- Unidirectional communication and broadcasting (a single group). It does not allow the individual direction of luminaires.
- Surface mounting on the ceiling.

Technical characteristics of the Dali constant regulation system:
- Supply voltage: 230VAC
- Frequency: 50/60Hz
- Output channels: 1
- Relay breaking capacity: 16A
- Type of connection terminals Lift
- Cable section: 2.5mm2
- Storage temperature (min): -30ºC
- Storage temperature (max): 70ºC
- Minimum delay: 10 minutes
- Maximum delay: 30 minutes
- Detection angle: 360º
- Mounting height: 2.5 m
- Detection diameter: 7m
- Own consumption: 2W
- Type of Load Ballast or DALI Driver
- Light level (min): 100lux
- Light level (max): 1000lux
- Maximum number of units: 64
- Installation: Ceiling surface
- Operating temperature: (min) 0ºC
- Operating temperature (max): 40ºC
- Environmental protection: IP20 according to UNE 20324
- According to the Standard: UNE-EN 60730