Dinuy return current compensator

- This device allows the absorption of residual or return currents that keep certain LED lamps on with some devices: regulators, motion detectors ...

- Placed in parallel to one of the lamps in the circuit, it allows them to be completely turned off in case they remain slightly on when trying to turn them off.

- In addition, it allows to increase the number of buttons, with pilot light, connected to the same remote control.

- In installations where there is no regulator or detector, only interruotires or switches, with or without a pilot light, it can also be used to absorb those possible residual currents that keep LED lamps on.

- Unlike other devices, this compensator does not have its own consumption, it does not modify the power factor of the lamps, it is only necessary to place one per circuit and its reliability is greater.

- Possibility of adjusting the minimum level of regulation of the lamps, avoiding unwanted flickering or turning off at low levels.

- Safety encapsulation to avoid accidental burns.

Return current compensator features:

Installation with switch with pilot light: In case that after a shutdown command, the 230V LED lamp remains slightly on, it will be necessary to place the accessory AC DM 003 parallel to one of the lamps in the circuit.

Installation together with the TE UNI 220 or TE UNI 024 remote control: It is possible to use this accessory to increase the number of buttons with neon, although it reduces the response frequency of the remote control.

Installation next to the DM CAM 003 detector: There are some lamps on the market that, due to their constructive characteristics, may blink at rest or prevent the detector from closing its contact.

Installation next to the RE PLA LE0 regulator: If the 230V LED lamp stays slightly on after a shutdown command, it will be necessary to place the accessory AC DM 003 parallel to one of the lamps in the circuit. - According to the Standard: UNE-EN 60669-2-1