Presence detector Dicromat + CR programmable with remote control Orbis

Main features of the programmable Dicromat+CR presence detector with remote control:
- Recessed mounting in practicable ceiling using a 65mm drill.
- It is the ideal model for installations with long corridors, since it allows additional DICROMAT sensors to be added SENSOR +.
- The additional sensors simplify and save installation, since it is not necessary to buy or wire several DICROMAT +CR.
- It can be programmed using the MANDO CR remote control.
- LED pilot light of status that turns on when the equipment detects movement and staggered regulation of timing.
- Zero crossing relay for better switching of loads type LED, fluorescence or low consumption.
- Adjustable parameters: catchment area, timing and light sensitivity.
- Once installed, it is not necessary to disassemble the equipment to adjust the parameters.
- Adjustable sensor to direct towards the capture area.
- Accessory: DICROMAT SENSOR + (OB133412), COMMAND CR (OB134712).
- Up to 4 DICROMAT SENSOR + can be added to the DICROMAT +CR model.

Technical characteristics of the presence detector Dicromat+CR programmable with remote control:
- Power supply : 230 V ac, 50 Hz
- Breaking power: 10A 230 V ac
- Timing: Circuit 1 from 10s to 10 min. Pulse function 1 s. / Circuit 2: from 10s to 15 min.
- Light sensitivity: Adjustable from 2-2,000 lux
- The circuit always reacts independently of the regulated brightness.
- Temp. operation: -10ºC to +45ºC
- Detection angle: 360º
- Detection field: Up to 7 m in diameter at 2.5 m height
- Maximum loads:
Incandescent lamps: 2200 W< br>Fluorescent: 1200 VA
Low voltage halogens: 2000 VA
Halogens (230V AC): 2200 W
Low consumption lamps: 1000 VA
LED: 500 VA
Downlights: 900 VA