Sanitrit Sanipro adaptable horizontal outlet grinder

It has 4 entrances to collect wastewater from:

- A WC with a horizontal outlet through its central entrance

- A washbasin through its upper entrance

- And a bidet through another of its low side entrances

Its flushing system Integrated pumping allows you to evacuate this wastewater up to 5 meters high or 100 meters horizontally, and that through a tube of only 32 mm in diameter. The start-up of the SANIPRO, like the other devices in the range, is automatic. The system works by the pressure exerted by the water entering the tank

The connections of the bathroom appliances (washbasin, shower and bidet) are made through 40 mm diameter tubes. The evacuation is carried out through an elbow (included) pre-equipped with a non-return valve. It is recommended to evacuate in 32 mm even if the elbow has various diameters available.

The SANIPRO sanitary disposer has the latest SFA developments on noise reduction. The device is equipped with a series of silent-blocks that absorb most of the transmitted noise. In addition, the device works with very short cycles of 2-3 seconds. This device does not emit more noise than an external cistern that is filled.

Technical characteristics of the Sanitrit Sanipro disposer Adaptable Horizontal Outlet:

- Weight: 6.4 kg

- Number of available inlets: 4

- Recommended evacuation diameter: 32 mm

- Consumption motor: 400 W

- Supply voltage: 220-240 V/50-60 Hz

- Protection index: IP44

- Maximum horizontal evacuation: 100 m

- Starting height: 70 ± 10 mm

- Amperage: 1.9 A

- Maximum temperature of incoming water: 38º C< /p>

- Flow rate at 3 meters: 75 L/min

- Inlets: 1 front + 1 upper + 2 laterals

- Diameter of lateral and upper inlets: 40 mm

- Outlet elbow diameter: 22/28/32 mm

- Type of power cable: 3 x 0.75 mm2 + plug

- Length power cable length: 1200 mm

- Shaft RPM: 2800

- Engine cooling: oil

- Type of turbine: bladed

- Capacitor capacity: 10 μf

- Recommended Ø of the evacuation tube in vertical sections: 32 mm