Valve A80 1/2 "male - 3/8" male without chrome nut Arch

A-80 FILTRO valves are used in indoor plumbing installations. Due to their characteristics, they are especially suitable to prevent the entry of small solids, lime deposits and other impurities, protecting elements of the installation such as the taps. They allow to cut off individually the water supply to sinks, sinks and other points of consumption to proceed with its repair or replacement.
The shaft and ball are made of a single piece made of European brass CW614N. This arrangement increases its resistance and facilitates a smooth maneuver. This original ARCO component is designed to reduce pressure losses, increase flow and prevent noise. A POM caliper housed inside the valve presses the NBR seat against the ball-shaft. This clamp and seat system cannot be removed, thus preventing tampering. Two NBR O-rings housed in the shaft ensure the outer seal. This double gasket system provides extra security against leaks, aging and wear. An O-ring guarantees the tightness between the threaded plug and the valve body.

Characteristics of the valve A · 80 1/2 "male - 3/8" male without chrome nut:
- They are maneuvered by a quarter turn of command.
- Nominal pressure: 16 bar.
- Temperature range: cold and hot water up to 95ºC.
- Filter and cap form the same piece to facilitate cleaning.