1" female AQUACONTROL solenoid valve

This solenoid valve with a 1" female connection and flow regulator. It incorporates a filter inside. It is made of nylon and fiberglass. The gaskets are made of rubber, ethylene, propylene (EPDM). Not recommended for use with wastewater. Exercise conditions : 24 VAC 50/60 Hz solanoid It comes packed in a bag.

Characteristics of the 1" female AQUACONTROL Solenoid Valve:
- Presentation: Box
- Maximum water temperature: 4-43 °C< br>- Starting current: 0.4 (9.6VA) A
- Regime current: 0.3 (7.2VA) A
- Flow: 5.67 m3/min.94.5 l/ min
- Pressure: 0.35 to 17.24 bar

THE EXPERT ADVICE:
MISTAKES TO AVOID
TREAT PLANTS THE SAME
Each plant has light needs , temperature, humidity and different water. It is advisable to find out in advance about the biology of outdoor plants in order to plan irrigation in a systematic, accurate and effective way.
FORGET TO WATER THEM
It seems obvious, but it is one of the most frequent mistakes. Or water them without a system: a few weeks more and others less or not at all because the previous week you already watered them too much. The best way is to schedule the irrigation or install an automated system.
ALWAYS WITH THE SAME FREQUENCY
This is another common mistake. In general, in summer and during flowering it is convenient to hydrate the plants more frequently, while in winter the watering will be less. When in doubt, a trick is to check the soil with your finger: if it is wet, it is not necessary to water.
EXCESSIVE WATERING
Not watering it is just as bad for the plant as watering it too much. An excess of water fills the voids in the substrate and expels the air. Without air, the roots suffocate and die. The symptoms that the plant will present will be the same as those due to drought (the leaves fall...).